project:reprap:tempset
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
project:reprap:tempset [2015/10/25 19:35] – yan | project:reprap:tempset [2015/11/01 09:21] (current) – [confirmed experimental settings] yan | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Temperature Setting ====== | ||
+ | Setting correct temperature is crucial for nice output and smooth operation of printer. | ||
+ | factors which can affect correct temperature are: | ||
+ | * extruder (manufacturer) | ||
+ | * filament type (ABS, PLA, PET..) and diameter (1.75/3 mm) | ||
+ | * manufacturer | ||
+ | * color of filament (sometimes different color of one manufacturer may vary) | ||
+ | |||
+ | As a good "first shot" setting temperature to filament manufacturer prescribed value is not a bad idea. I ussualy **start with values published by Prusa [[http:// | ||
+ | |||
+ | **Feel free to vary temperature if first time you don't get ideal result, experimental data is crutial!** | ||
+ | |||
+ | === malfunctioning affected by temperature === | ||
+ | low bed temperature -> model doesn' | ||
+ | filament jamming (brushed from extruder drive) -> can be caused by low temperature, | ||
+ | |||
+ | ===== confirmed experimental settings ===== | ||
+ | **Drevena - PLA** - **bed 55 °C**, extruder - **190+ °C** - used on transparent red and non-transparent black PLA, both with sucess, lower bed temperature may result into problems with adhesion of filament to bed. |