STATUS:
Contact
| ||||
|---|---|---|---|---|
| Day | Events | |||
| 12/10 Tuesday | 2000 meetup | |||
| 12/11 Wednesday | ||||
| Day | Events | |||
Sponsors
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
project:reprap:anytime [2019/08/08 08:55] rainbof [3d printing cookbook] |
project:reprap:anytime [2019/08/08 08:55] (current) rainbof [3d printing cookbook] - price update |
||
|---|---|---|---|
| Line 29: | Line 29: | ||
| * do not leave few cm of filament in printer, install new filament | * do not leave few cm of filament in printer, install new filament | ||
| * if it broke or you broke it - nevermind, * * * * happens. Report it and leave a note on printer | * if it broke or you broke it - nevermind, * * * * happens. Report it and leave a note on printer | ||
| - | * dont forget to weight extruded plastic and pay for it (**2 CZK/g** if you´re member, **5 CZK/g** for non-member) | + | <del> * dont forget to weight extruded plastic and pay for it (**2 CZK/g** if you´re member, **5 CZK/g** for non-member)</del> |
| ==== Bed preparation ==== | ==== Bed preparation ==== | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
