Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
project:cncduino [2016/11/25 08:16]
ruza ↷ Links adapted because of a move operation
project:cncduino [2016/11/25 09:14] (current)
ruza ↷ Links adapted because of a move operation
Line 11: Line 11:
 }} }}
  
-In lots of brmlab projects ([[project:​brmscope:​start]],​ [[project:​lasercutter]]) some kind of XY/​[[https://​en.wikipedia.org/​wiki/​Cartesian_coordinate_robot|cartesian robot]] is used. Goal of this project is to provide board and ATmega firmware as simple and cheap as possible designed to control stepper-motors-based XYZ robots.+In lots of brmlab projects ([[project:​brmscope:​start]],​ [[project:​lasercutter:start]]) some kind of XY/​[[https://​en.wikipedia.org/​wiki/​Cartesian_coordinate_robot|cartesian robot]] is used. Goal of this project is to provide board and ATmega firmware as simple and cheap as possible designed to control stepper-motors-based XYZ robots.
  
 This will include power transistors to drive motors and maybe some optocoders or at least zero-position sensors. This will include power transistors to drive motors and maybe some optocoders or at least zero-position sensors.
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki